Pipeline Magnets
Pipeline magnets apply to tiny Road ferromagnetic metal particles are removed in a variety of liquid and slurry products. A strong magnetic properties can be eliminated from the product stream, the particles of low-magnetic stainless steel, to ensure rapid and efficient impurity separation.
Pipeline magnets used to remove iron magnetic impurities in the liquid and slurry, widely used in food, plastics, chemical, rubber, pharmaceutical, ceramic, environmental protection, pigments, dyes, and other industries.
Materials go through the equipment, ferromagnetic materials will be adsorbed on the pipeline wall.If you would like to eliminate the ferromagnetic materials,just open the side door to take them out.
- Condition: Well polished.
- All of magnetic bars are waterproof.
- 100% Stainless Steel construction.
- Liquid tight with food grade O-rings.
- Easy-clean type can be provided on request.
- Easy access for inspection and maintenance.
- Tri-clamp, Bevel-seat (Acme thread), or weld end inlet and outlets.
- It can be fastened by screw nuts; it also can be fastened by band clamp.
- It is equipped with high-energy Rare-earth Magnets. Diameter of magnetic bar is 1".
- Construction uses Type 304 stainless steel. Type 316 stainless steel available on request.
- Highest grade of magnet material with choices including Neodymium-Iron-Boron(rare-earth), Samarium-Cobalt (rare-earth), Ceramic and Alnico.
| Groups | Products |
| Group 1 - Fluid and strained Products | Beverages, thin soups, juices, jellies, light sauces, custard, syrups & salad dressing. |
| Group 2 - Fibrous & Crushed Products | Crushed fruits & Vegetables, chopped foods, medium syrups, vegetable soups, thick salad dressing. |
| Group 3 - Viscous or heavy Products | Thick puddlings, hot processed, creamed cheese, baby foods, frozen slush, heavy sauces, thin batters, heavy purees, heavy syrup, warm jam. |
| Group 4 - Viscous & Fibrous Products | Minced meat, ground meat products, pet foods, warm preserves, meat emulsion, thick batters, meat spreads, other viscous products. |
Pipeline Magnets Applications
- All units incorporate a sump type housing to trap non-ferrous particles.
- Efficiently remove tramp iron before maintenance and product contamination problems occur.
- Liquid Trap Magnets are engineered to remove ferrous contaminants from liquid and slurry lines.
- Liquid Traps may be installed horizontally, vertically, or on an angle without affecting their magnetic efficiency.
- The benefits of this magnetic separator can be experienced in most cases with no appreciable pressure drop or reduction in flow rates.
Pipeline Magnets Types
Cage Style "T" Traps:
T-Trap Magnetic separators are designed for heavy duty, large volume liquid and semi-liquid line flow systems. The T-Trap employs a slip-in cage of stainless steel permanent magnetic tubes, which capture ferrous tramp metal particles and improve the purity of the product. As the particles collect, they migrate to the rear of the tubes where they remain protected from wash-off until the tubes are cleaned. With its top access bolt-on steel plate and seal, the T-Trap is easy to clean. Simply remove the top, lift out the magnet cage, wipe clean and reinstall. Available in 7 standard line sizes from 2" to 18" inches in diameter, STR T-Trap's can also be produced to meet special applications. EZ-Clean upgrade packages are available for some styles of manual clean, cage style T-Traps.
Cage Style "T" Traps:
When tramp metal protection is required for liquid lines carrying viscous to fibrous products, the plate style T-Trap is ideal. This magnet allows the product to flow through the housing without causing product bridging. An interior baffle is used to direct the entire product flow towards the powerful plate magnet, ensuring that tramp metal is forced into the magnetic field. Installation of the plate style magnet can be in any position. Vertical position eliminates the sump area, and in horizontal lines, cleaning is made easier when the magnet element is installed on top. Available in standard line sizes of 2" and 3" diameters. STR can also manufacture magnets for special applications or line sizes.
Pipeline Magnets Specification
| CAGE STYLE | |||||||||||||
| ALL DIMENSION ARE IN INCHES | Litres/Min |
||||||||||||
| Part No | A | B | C | D | E | F | G | H | Group1 | Group 2 | Group 3 | Group 4 | Weight Kg |
| STR 02 | 2 | 10 | 6 | 7.5 | 3.25 | 7.5 | -9 | 5 | 546 | 382 | 191 | 82 | 13.2 |
| STR 02.5 | 2.5 | 12 | 7.5 | 9.75 | 4.38 | 9.75 | 0 | 7 | 909 | 638 | 318 | 136 | 22.7 |
| STR 03 | 3 | 12 | 9 | 9.75 | 4.38 | 9.75 | 0 | 7 | 909 | 636 | 318 | 136 | 22.7 |
| STR 04 | 4 | 12 | 12 | 10.25 | 4.38 | 9.75 | 0 | 7 | 1227 | 859 | 432 | 186 | 27.2 |
| STR 06 | 6 | 23 | 18 | 16 | 13.38 | 10.75 | 11 | 9 | 7273 | 5091 | 2545 | 1236 | 104.4 |
| STR 08 | 8 | 26 | 24 | 19 | 17.25 | 12.75 | 13.5 | 9 | 7273 | 5091 | 2545 | 1236 | 124.7 |
| STR 10 | 10 | 30 | 30 | 23.5 | 21 | 16 | 16 | 15 | 7273 | 5091 | 2545 | 1236 | 261 |
| STR 12 | 12 | 34 | 36 | 25 | 21 | 18 | 19 | 15 | 14318 | 10023 | 500 | 2432 | 295 |
| STR 14 | 14 | 36 | 42 | 27.5 | 23.38 | 20 | 21 | 15 | 14371 | 10023 | 500 | 2432 | 333.5 |
| STR 16 | 16 | 40 | 46 | 32 | 25.63 | 24 | 23.5 | 17 | 23836 | 18545 | 8273 | 4000 | 442.4 |
| STR 18 | 18 | 40 | 50 | 32 | 27.5 | 24 | 25 | 17 | 23836 | 16545 | 8273 | 4000 | 476.4 |
| PLATE STYLE | |||||||||
| Model no. | A | B | C | D | Group1 | Group 2 | Group 3 | Group 4 | Weight Kg |
| STR-15 | 1.5" | 4.25" | 5.50" | 10.0" | 245 | 189 | 94 | 57 | 8 |
| STR-20 | 2.0" | 4.25" | 5.50" | 10.0" | 245 | 189 | 94 | 57 | 8 |
| STR-25 | 2.5" | 4.75" | 7.75" | 13.5" | 528 | 339 | 226 | 132 | 14 |
| STR-30 | 3.0" | 4.75" | 7.75" | 13.5" | 528 | 339 | 226 | 132 | 14 |
- Technical data specification subject to change.
- Special Liquid Line Separators Specification can be made on request, Please send us your technical data to our engineers.